Designed to simplify the Internet of Intelligent Things (AIoT) by integrating the power of ESP32
Offers reliable Wi-Fi and Bluetooth connectivity
x3 Ports Maker, compatible with Qwiic, STEMMA QT and Grove
Board preloaded with CircuitPython, also compatible with Arduino IDE, MicroPython and Espressif IDF
Maker Feather AIoT S3 development board (version without pre-welded female connectors)
x3 Grove to JST-SH cables (Qwiic / STEMMA QT)
ESP32-S3 WROOM 1 N8R8 module, 240MHz clock, 8MB Flash memory, 320KB RAM
x2 Horizontal Maker Ports, powered by 3.3V Vperephical
Vertical Maker port, powered by 3.3V (always on)
Single-cell LiPo connector with overload/overdischarge protection circuit, rechargeable via USB-C
x28 PIN GPIO Breakout
x11 GPIO status indicator LEDs
RGB LED (WS2812B Neopixel)
Programmable piezo buzzer
Reset button
User-programmable button
Boot button
Supports Arduino, CircuitPython, MicroPython and Espressif IDF
*GPIO LEDs, Piezo Buzzer and Maker Port (H) are powered by the Vperipheral. Make sure it is activated by switching on D11 before using them.
Vperipheral is enabled by default for CircuitPython and Arduino Core. It must be activated manually for Espressif IDF.
No customer questions for the moment.
Designed to simplify the Internet of Intelligent Things (AIoT) by integrating the power of ESP32
Offers reliable Wi-Fi and Bluetooth connectivity
x3 Ports Maker, compatible with Qwiic, STEMMA QT and Grove
Board preloaded with CircuitPython, also compatible with Arduino IDE, MicroPython and Espressif IDF
Français
Español
Italiano
Deutsch
Portugais
