2-channel Ethernet to UART converter for Raspberry Pi Pico Supports seamless transmission of 2-CH Ethernet to UART data Integrated female pin header for direct attachment to theroches of the Raspberry Pi Pico 10/100M auto-negotiating Ethernet interface
Connectivity Raspberry Pi, compatible with Raspberry Pi Zero / Zero W / Zero WH / 2B / 3B / 3B + / 4 CAN function, integrated CAN controller MCP2515 via SPI interface, integrated transceiver SN65HVD230 RS485 function, controlled via UART, half-duplex communication, supports automatic TX / RX...
Increase the capabilities of your Raspberry Pi The original Raspberry Pi has only one UART port with 1 channel. With this serial extension, you have a UART with two channels as well as 8 GPIOs programmable via I2C. The LEDs integrated in the extension allow you to monitor the UART operating status.
Compatible with Raspberry Pi A, B, A+, B+, Zero, 2, 3 with its L80-39 GPS chipCommunicates satellite data via UART or USBCP2102 as a stable and faster UART chip USB bridge66 simultaneous search channels and 22 tracking channelsAdvanced AGPS EASY™ technology without external memory USB cable not...
Raspberry Pi + LoRa (TM) expansion board with HopeRF LoRa (TM) radio module(s) installed. Comes with appropriate manifold and spacers, SMA and modules installed. The first module purchased will be installed in slot CE1, the second in slot CE0. If you plan to use this board in conjunction with...
It is a low power HAT Raspberry Pi, equipped with multiple communication features: GSM, GPRS, GNSS and Bluetooth. It allows your Pi to easily make a phone call, send messages, connect to the Internet wirelessly, global position, transfer data via Bluetooth, and so on. GPS antenna not included.
Looking for an expansion that supports both the Hailo 8L AI module and NVMe storage? Provides two M.2 2230/2242/2280 M-Key slots for your NVMe boot storage Features an M.2 2230 A/E-Key connector, to accommodate the AI Hailo 8L gas pedal (included) The included Hailo-8L module...
Boost your Raspberry Pi 5 by adding an NVMe SSD for lightning-fast performance! The official M.2 HAT+ allows you to connect M.2 (M-Key) devices to the Raspberry Pi 5's PCIe connector using the included cable 4 Gbps PCIe 2.0 interface for fast data transfer (~500Mbytes/s) to and from...
HAT+ for Raspberry Pi 5, compatible with M.2 SSD size 2230 and 2242 Supports PCIE X1 Gen2 only, does not support booting Pi 5 from SSD Dual Built-in LED Indicators for operational status monitoring HAT+ design with integrated EEPROM chip
Français
Español
Italiano
Deutsch
Portugais
